Metrology.NET®

TestProcess.Measure.Pressure.Pneumatic.Absolute.Static

This test process measures the pneumatic absolute pressure generated by the unit under test. The resulting measured will be in the unit of measure as defined in the test point’s data.

Note: Although the unit of measure can be read from the test point’s unit of measure it is good practice to pass the Unit of Measure to the test process as a parameter to avoid confusion when synchronizing data between systems.

https://en.wikipedia.org/wiki/Pressure_measurement

https://www.nxp.com/docs/en/application-note/AN1573.pdf?&srch=1

Required Parameters

  • Pressure 
  • UnitOfMeasure – {μmHg, mmHg, mHg, μmH2O, mmH2O, mH2O, inHg, inH2O, psi, μPa,  mPa, Pa, kPa, MPa, mbar, bar, Torr}

Optional Parameters

  • O2_Safe – “Yes” If the Gage in an O2 environment

Measured Value & Uncertainty

  • Pressure

Leave a Reply